Description

Earthworks M30 Omnidirectional Condenser Measurement Microphone Up to 30kHz

The M30 works with any high-quality FFT-based real-time audio system measurement software, like SMAART™, SIM™, REW™, Electroacoustics Toolbox™, FuzzMeasure™ and others, as well as for use in PA system alignment and loudspeaker design.
Every M30 is individually hand-tuned and tested and is delivered with its own printed frequency response chart. An Electronic Calibration File (ECF) is generated for each microphone during final testing, and can be downloaded free of charge after product registration.

Features:
Cost effective measurement microphone
Ideally suited for acoustical measurements sound system setup and troubleshooting, room acoustics, or any application where an accurate free-field measurement microphone is required
Omnidirectional polar pattern
Flat frequency response, fast impulse response and exceptional polar characteristics
Used by SMAART™, MLSSA™, Spectrafoo™, TEF™ and RTA in addition to acoustic measurement systems manufactured by dbx, DEQX and others
Meets or exceeds ANSI Type 1 and applicable IEC 61094 requirements
Requires 48V Phantom Power
Each M Series microphone is delivered with its own calibration chart providing its individually measured open-circuit sensitivity and the frequency response curve

Specifications:
FREQUENCY RESPONSE 3Hz to 30kHz
POLAR PATTERN Omnidirectional
SENSITIVITY 34mV/Pa (-29dBV/Pa)
POWER REQUIREMENTS 24-48V Phantom, 10mA
MAX ACOUSTIC INPUT 140dB SPL
OUTPUT XLR (pin 2+)
OUTPUT IMPEDANCE 65Ω balanced (between pins 2 & 3)
MIN OUTPUT LOAD 600Ω between pins 2 & 3
NOISE 20dB SPL equivalent (A weighted)
DIMENSIONS (L x D) 229mm x 22mm (9.0 x .860 inches)
WEIGHT .5 lb. (225g)