Ashly SRA-2150 2 Channel Rackmount Stereo Power Amplifier 300 Watts

Ashly SRA-2150 2 Channel Rackmount Stereo Power Amplifier 300 Watts

Specifying the right power amp is often easier than finding it. Ashly's SRA-Series makes it a snap to get exactly what you need. The SRA-Series utilizes state of the art technology to create advanced, efficient amplifiers perfect for installations with modest power requirements. Four models are available in two and four channel configurations with power ratings of 75W and 150W per channel.

SRA-Series of amplifiers are housed in a compact 1RU chassis weighing 10 lbs. or less and are designed to drive four or eight ohm loads. The 150W models are capable of driving 25V constant voltage lines directly. Switch-mode-power supplies and Class-D amplifier circuitry provide an extremely power-efficient solution for a wide variety of low wattage applications.

All SRA-Series amplifiers are convection-cooled, so there's little maintenance after the installation, and no annoying fan noise. Of course you get the reliability, superior sonic quality and rugged construction you've come to expect from Ashly.

Features:
Convection cooling
Extremely low noise
Extensive protection circuitry
Level attenuators for each channel
Signal present and clip alert status L.E.D.'s
Stereo headphone jack
Euroblock inputs/outputs
Selectable input sensitivity and HPF
Normal or bridged mode switch on each channel
Remote power turn-on/off
Adjustable turn-on delay up to eight seconds

Specifications:
Frequency Response (8 Ohms): 20Hz–20kHz, ±1.0dB
Distortion (SMPTE, typical): < 0.5% - 8 Ohm load, 10dB below rated power
Distortion (THD-N, typical): < 0.5% - 8 Ohm load, 10dB below rated power, 20Hz–20kHz
Damping Factor (8 Ohm load, < 1 kHz): > 200 into 8 Ohms
Input Impedance: 20k Ohms, Balanced
Input Sensitivity: 1dBu (75W), 4dBu (150W)
Gain: 26dBu, 36dBu, Selectable
Maximum Input Level: +21dBu
HPF: 80Hz 2nd Order, defeatable
Cooling: Convection
Output Circuitry: Class D
Amplifier/Load Protection: Output Overcurent, DC Output, Main Supply Rail Overvoltage, Chassis Temperature, Inrush Limiting, Mains Fuse
Environmental: 40-120° F, (4-49° C) noncondensing
Front Panel
Controls: AC Power Switch, Level
Indicators (LED color): Power (Blue), Standby (Yellow), Protect (Red), Signal (Green), Clip (Red)
Rear Panel
Controls: 80Hz HPF, Gain/Sensitivity: +26dB, +36dB, Bridge/Stereo Switch, Remote Standby, Delay
Connectors (each channel):
Input: 3-Pin Euroblock
Output: Euroblock
Cordset: 3-Prong IEC